Corrosion Solutions

A proven, dependable method of joining pipe.

• Economical alternative to welding, threading, or flanges and are easy-to-install clamshell design
• Firmly grips along the full pipe circumference
• Not available in the America

A proven, dependable method of joining pipe.

• Economical alternative to welding, threading, or flanges and are easy-to-install clamshell design
• Firmly grips along the full pipe circumference
• Not available in the America

A proven, dependable method of joining pipe.

• Economical alternative to welding, threading, or flanges and are easy-to-install clamshell design
• Firmly grips along the full pipe circumference
• Not available in the America

Reduce problems created by corrosion with the help of the Tyco® Gas Sampling Kit, which includes the THGA Handheld Gas Analyzer and the TGSP Gas Sampling Port.

A key component in your efforts to avoid the problems created by corrosion, the Tyco® THGA Handheld Gas Analyzer verifies nitrogen concentration in a fire sprinkler system using Tyco® Dry Pipe Nitrogen Inerting (DPNI) technology.

An essential component for a Tyco® Nitrogen Generator system, the TGSP Sampling Port is equipped with both a quick connect and isolation valve, as well as industrial brass couplers.

The Tyco® TAV-D Dry System Air Vent provides oxygen venting in dry pipe fire sprinkler systems.

As a fire sprinkler system is filled with a continuous supply of nitrogen gas from a Tyco® NG-1 Nitrogen Generator, the TSV-D SMART Air Vent allows oxygen-rich gas to be vented from the fire sprinkler system.

As a fire sprinkler system is filled with water, trapped gases migrate to the high point of the system, where a vent would be installed to allow gases to escape.

The Tyco® TILD In-Line Corrosion Detector is designed to be installed where corrosion is most likely to occur — the air/water interface. The TILD features roll-grooved ends to allow for easy integration into the system.

The TNIC allows corrosion control of both dry and preaction fire sprinkler systems operating at two different pressures while connected to one nitrogen source – eliminating the need for two separate nitrogen sources.

The TNIK Nitrogen Inerting Kit helps perform the Wet Pipe Nitrogen Inerting (WPNI) process, which replaces the oxygen in the system with nitrogen to help stop the corrosion process in a fire sprinkler system.

The Nitrogen Injection Port is used as part of the Wet Pipe Nitrogen Inerting (WPNI) process to provide internal corrosion control for wet pipe fire sprinkler systems.

For use during the Wet Pipe Nitrogen Inerting process, the Tyco® TRIS Remote Inerting Station makes it possible to perform certain tasks without accessing the TAV-WN Air Vent and can be located near the ground in a more accessible location.

Designed to be installed in-line between the house/plant nitrogen supply and the sprinkler system riser in wet pipe sprinkler systems, the Nitrogen Inerting Manifold includes a pressure regulator to control the nitrogen flow during the deployment of the Wet Pipe Nitrogen Inerting (WPNI) process.

The TNST-200 Nitrogen Storage Tank is intended for use in conjunction with a Tyco® NG-1 Nitrogen Generator for controlling oxygen corrosion in wet pipe fire sprinkler systems.